CMP0026

警告

該方針的 OLD 行為已在 CMake 版本 4.0 中移除。該方針必須透過呼叫 cmake_minimum_required() 或 cmake_policy() 設定為 NEW。

Disallow use of the LOCATION property for build targets.

CMake 2.8.12 and lower allowed reading the LOCATION target property (and configuration-specific variants) to determine the eventual location of build targets. This relies on the assumption that all necessary information is available at configure-time to determine the final location and filename of the target. However, this property is not fully determined until later at generate-time. At generate time, the $<TARGET_FILE> generator expression can be used to determine the eventual LOCATION of a target output.

Code which reads the LOCATION target property can be ported to use the $<TARGET_FILE> generator expression together with the file(GENERATE) subcommand to generate a file containing the target location.

The OLD behavior for this policy is to allow reading the LOCATION properties from build-targets. The NEW behavior for this policy is to not to allow reading the LOCATION properties from build-targets.

此方針於 CMake 版本 3.0 中引入。在 CMake 版本 4.0 移除之前，它可以透過 cmake_policy() 或 cmake_minimum_required() 設定。如果未設定，CMake warned，並使用 OLD 行為。